Door Hardware - Heartland VALUE Series Assembly Manual

PARTS REQUIRED:
x1
BEGIN
1 Place bolt onto OO in open position with bolt end 1/4" down from frame.
Bolt is open when loop is contacting base (Fig A) .
Mark and pre-drill holes for screws.
2
Install bolt with screws supplied and drill 5/16" hole for bolt to extend into door frame.
Install hasp on right door and latch on left door. Bottom edge of hasp is
3
35-1/2" (90 cm) up from bottom edge of door trim. Measure and mark locations and
install with 3/4" screws as shown (Fig B)
FINISH
4
LEFT
DOOR

DOOR HARDWARE

x1
x7
3/4" (1,9 cm)
.
35-1/2"
(90 cm)
DOOR
5/16" (0,8 cm) Drill Bit
LOCATE AND PRE-DRILL HOLES TO AVOID SPLITTING WOOD
OVER DOOR FRAME
OO
2 x 3 x 69"
x4
OPEN POSITION,
Spring is loose.
43
x4
1" (2,5 cm)
Fig. A
5/16" drill for bolt:
1" deep.
1/4" with bolt in open
position.
Loop contacts
3/4" (1,9 cm) Screw x7
Fig. B
PRE-DRILL
(4) HOLES
base.