Set Communication - ADF Web HD67667-2-A1 User Manual

Industrial Electronic Devices

SET COMMUNICATION:

This section define the fundamental communication parameters of two buses,
EtherNet/IP and Serial.
By Pressing the "Set Communication" button from the main window for SW67667 (Fig.
2) the window "Set Communication" appears (Fig. 3).
The means for the fields for the "Serial" are:
In the field "Serial" the type of serial port used is defined;
In the field "Baudrate" the baud rate for the Serial side is defined;
In the field "Parity" the parity for the Serial side is defined;
In the field "Stop Bits" the number of Stop Bit is defined.
The means of the fields for "EtherNet/IP Master" are:
In the fields "IP ADDRESS" the IP address for EtherNet/IP side of the converter
is defined;
In the fields "SUBNET
converter is defined;
In the fields "GATEWAY" the default gateway of the net is defined. This feature
can be enabled or disabled pressing the Check Box field. This feature is used for
going out of the net;
In the field "Port" the port used for EtherNet/IP communication is defined. The
port has a fixed value of 44818.
ADFweb.com S.r.l.
Mask" the SubNet Mask for EtherNet/IP side of the
User Manual EtherNet/IP Master/ Serial
Document code: MN67667_ENG Revision 1.000
Figure 3: "Set Communication" window
Page 20 of 30