Connection Cap With M12 Connectors; Connection Of The Shield - Datalogic DeviceNet AMT58 Series Instruction Manual

4.4 Connection cap with M12 connectors

BC-FD-C connection cap is fitted with two M12 connectors with pin-
out in compliance with DeviceNet standard.
Therefore you can use standard DeviceNet cables commercially
available.
M12 connector
A coding
(frontal side)
1
CAN Shield is also connected to pin 1 to allow the connection of
the shield even if the plug connector has a plastic case.

4.5 Connection of the shield

Disentangle and shorten the shielding 1 and then bend it over the
part 2; finally place the ring nut 3 of the connector. Be sure that the
shielding 1 is in tight contact with the ring nut 3.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
(BUS IN)
Pin
Case
1
1
+10VDC +30VDC Supply
2
3
4
5
AMT58x-DN DeviceNET®
male female
(BUS OUT)
Function
CAN Shield
voltage
0 VDC Supply voltage
CAN High
CAN Low
9