Table of Contents
Advertisement
and then illuminates.
If initialization cannot be completed after
performing the above procedure, con-
tact a SUZUKI dealer or a qualified
workshop.
WARNING
When initializing the tire pres-
■
sure warning system
Do not initialize tire inflation pressure
without first adjusting the tire inflation
pressure to the specified level. Other-
wise, the tire pressure warning light
may not come on even if the tire infla-
tion pressure is low, or it may come
on when the tire inflation pressure is
actually normal.
Registering ID codes
Every tire pressure warning valve
and transmitter has a unique ID
code. When replacing a tire pres-
sure warning valve and transmitter,
it is necessary to register the ID
code.
When registering the ID codes, per-
form the following procedure.
1
Park the vehicle in a safe place,
wait for approximately 20 min-
utes, and then start the hybrid
system.
7-3. Do-it-yourself maintenance
2
Press
or
of the meter
control switches on the steering
wheel and select
3
Press
or
of the meter
control switches and select
"Vehicle Settings", and then
press and hold
4
Press
or
of the meter
control switches and select
"TPWS", and then press
5
Press
or
of the meter
control switches and select
"Identifying Each Wheel & Posi-
tion". Then press and hold
until the tire pressure warning
light starts slowly blinking 3
times.
The change wheel set mode is acti-
vated and registration is started.
Then a message will be displayed on
the multi-information display.
When registration is being performed,
the tire pressure warning light will blink
for approximately 1 minute then illumi-
nate and "--" will be displayed for the
inflation pressure of each tire on the
multi-information display.
467
.
.
.
7
Advertisement
Table of Contents
