Table of Contents
Advertisement
NOTICE
Do not apply coatings that have a
●
rain clearing (hydrophilic) effect, or
other coatings, to the lower center
part of the rear bumper.
Do not park the vehicle near objects
●
that may move and contact the
lower center part of the rear
bumper, such as grass or trees.
If the vehicle has been parked for a
while near objects that may move
and contact the lower center part of
the rear bumper, such as grass or
trees, the kick sensor may not oper-
ate. In this situation, move the vehi-
cle from the current position and
then check if the kick sensor oper-
ates. If it does not operate, have the
vehicle inspected by a SUZUKI
dealer or a qualified workshop.
●
Do not subject the kick sensor or its
surrounding area to a strong
impact.
If the kick sensor or its surrounding
area has been subjected to a strong
impact, the kick sensor may not
operate properly. If the kick sensor
does not operate in the following
situations, have the vehicle
inspected by a SUZUKI dealer or a
qualified workshop.
• The kick sensor or its surrounding
area has been subjected to a strong
impact.
• The lower center part of the rear
bumper is scratched or damaged.
Do not disassemble the rear
●
bumper.
Do not attach stickers to the rear
●
bumper.
Do not paint the rear bumper.
●
If a bicycle carrier or similar heavy
●
object is attached to the power back
door, disable the Hands Free
Power Back Door. (P.177)
4-2. Opening, closing and locking the doors
Changing settings of the
power back door system
The settings of the power back door
system can be changed by select-
ing the "Vehicle Settings" from the
screen of the multi-information
display and displaying the "PBD"
screen. (P.177)
The changed power back door settings
are not reset by turning the power
switch to OFF. In order to restore the
original settings, they need to be
changed back on the
multi-information display.
Adjusting the open position
of the back door
The open position of the power
back door can be adjusted.
1
Stop the back door in the desir-
able position. (P.197)
2
Press and hold the power back
door switch on the back door for
approximately 2 seconds.
When the settings are completed, the
buzzer sounds 4 times.
When opening the back door the next
time, the back door will stop at that
position.
205
screen of the
4
Advertisement
Table of Contents
