Table of Contents
Advertisement
C
Antennas inside the cabin
Effective range (areas within which
■
the electronic key is detected)
A
When locking or unlocking the doors
The system can be operated when the
electronic key is within about 0.7 m (2.3
ft.) of the front door handles, rear door
handles (if equipped) and back door
opener switch. (Only the doors detecting
the key can be operated.)
B
When starting the hybrid system or
changing power switch modes
The system can be operated when the
electronic key is inside the vehicle.
If an alarm sounds or a warning
■
message is displayed
An alarm sounds and warning message
displays shown on the multi-information
display are used to protect against
unexpected accidents or theft of the
vehicle resulting from erroneous opera-
tion. When a warning message is dis-
played, take appropriate measures
based on the displayed message.
When only an alarm sounds, circum-
stances and correction procedures are
as follows.
4-2. Opening, closing and locking the doors
When an exterior alarm sounds once
●
for 5 seconds
Situation
An attempt was
made to lock the
vehicle while a
door was open.
When an interior alarm pings continu-
●
ously
Situation
The power switch
was turned to ACC
while the driver's
door was open (or
the driver's door
was opened while
the power switch
was in ACC).
Battery-saving function
■
The battery-saving function will be acti-
vated in order to prevent the electronic
key battery and the 12-volt battery from
being discharged while the vehicle is not
in operation for a long time.
In the following situations, the smart
●
entry & start system may take some
time to unlock the doors.
• The electronic key has been left in an
area of approximately 3.5 m (11.5 ft.)
of the outside of the vehicle for 2 min-
utes or longer.
• The smart entry & start system has
not been used for 5 days or longer.
If the smart entry & start system has
●
not been used for 14 days or longer,
the doors cannot be unlocked at any
doors except the driver's door. In this
case, take hold of the driver's door
handle, or use the wireless remote
control or the mechanical key, to
unlock the doors.
207
Correction proce-
dure
Close all of the
doors and lock the
doors again.
Correction proce-
dure
Turn the power
switch to OFF and
close the driver's
door.
4
Advertisement
Table of Contents
