Table of Contents
Advertisement
346
5-5. Using the driving support systems
Press and hold the "-SET" switch.
Enabling/Disabling the
Dynamic Radar Cruise Con-
trol with Road Sign Assist
Dynamic Radar Cruise Control with
Road Sign Assist can be
enabled/disabled in the
on the multi-information display.
(P.177)
Dynamic radar cruise control with
■
full-speed range can be set when
●
The shift lever is in D.
The desired set speed can be set
●
when the vehicle speed is approxi-
mately 30 km/h (20 mph) or more.
(However, when the vehicle speed is
set while driving at below approxi-
mately 30 km/h [20 mph], the set
speed will be set to approximately 30
km/h [20 mph].)
Accelerating after setting the vehi-
■
cle speed
The vehicle can accelerate by operating
the accelerator pedal. After accelerat-
ing, the set speed resumes. However,
during vehicle-to-vehicle distance con-
trol mode, the vehicle speed may
decrease below the set speed in order
to maintain the distance to the preceding
vehicle.
When the vehicle stops while fol-
■
low-up cruising
Pressing the "+RES" switch while the
●
vehicle ahead stops will resume fol-
low-up cruising if the vehicle ahead
starts off within approximately 3 sec-
onds after the switch is pressed.
If the vehicle ahead starts off within 3
●
seconds after your vehicle stops, fol-
low-up cruising will be resumed.
■
Automatic cancelation of vehicle-
to-vehicle distance control mode
Vehicle-to-vehicle distance control mode
is automatically canceled in the follow-
ing situations.
VSC is activated.
●
●
TRC is activated for a period of time.
When the VSC or TRC system is
●
turned off.
screen
●
The sensor cannot detect correctly
because it is covered in some way.
Pre-collision braking is activated.
●
The parking brake is operated.
●
●
The vehicle is stopped by system con-
trol on a steep incline.
The following are detected when the
●
vehicle has been stopped by system
control:
• The driver is not wearing a seat belt.
• The driver's door is opened.
• The vehicle has been stopped for
about 3 minutes
If vehicle-to-vehicle distance control
mode is automatically canceled for any
reasons other than the above, there
may be a malfunction in the system.
Contact a SUZUKI dealer or a qualified
workshop.
Automatic cancelation of constant
■
speed control mode
Constant speed control mode is auto-
matically canceled in the following situa-
tions:
Actual vehicle speed is more than
●
approximately 16 km/h (10 mph)
Advertisement
Table of Contents
