WARNING
Onboard traction battery charger
■
The onboard traction battery charger
is located under the rear seats. Make
sure to observe the following precau-
tions regarding the onboard traction
battery charger. Failure to observe
these precautions may result in death
or serious injury such as burns and
electric shocks.
The onboard traction battery char-
●
ger is hot during charging. Do not
touch the onboard traction battery
charger, as doing so may result in
burns.
Do not disassemble, repair or mod-
●
ify the onboard traction battery
charger. When the onboard trac-
tion battery charger needs to be
repaired, consult a SUZUKI dealer
or a qualified workshop.
NOTICE
When charging
■
Do not insert the plug into the AC
charging inlet.
The AC charging inlet may be dam-
aged.
Using private power generator
■
Do not use private power generators
as a power source for charging.
Doing so may make charging unsta-
ble, the voltage may be insufficient,
and the error warning indicator on the
CCID (Charging Circuit Interrupting
Device) of the AC charging cable may
flash.
Charging station
■
Due to the environment in which the
power equipment is located, charging
may be unstable due to noise, the
voltage may be insufficient, and the
error warning indicator on the CCID
(Charging Circuit Interrupting Device)
of the AC charging cable may flash.
2-2. Charging
■
Onboard traction battery char-
ger cooling air intake vent
Cooling air intake vent for the
onboard traction battery charger is
installed under the rear seats.
Make sure to observe the following
precautions regarding the cooling air
intake vent. Failure to observe these
precautions may result in a charging
system malfunction.
Do not block the air intake vent with
●
seat covers or luggage
●
If the air intake vent is clogged with
dust, clean it with a vacuum cleaner
Do not allow water or foreign matter
●
to enter the air intake vent
Do not spill large amounts of water
●
near the air intake vent
If water is spilled, have the vehicle
inspected by a SUZUKI dealer or a
qualified workshop and do not
charge the hybrid battery (traction
battery) before the inspection.
After charging
To prevent electrical shock, be sure
to remove by following the proce-
dures below.
1
Unlock the doors to unlock the
charging connector. (P.115)
The charging connector will be
unlocked and the AC charging inlet light
will illuminate when the doors are
unlocked.
If the charging connector is unlocked
133
2