Table of Contents
Advertisement
130
2-2. Charging
4
Remove the AC charging inlet
cap and secure it into the holder
on the charging port lid.
5
Remove the charging connec-
tor cap and secure it to the
cable.
6
Make sure to hold the body of
the charging connector and
insert it firmly and fully into the
AC charging inlet.
When connecting the charging connec-
tor into the AC charging inlet, make
sure that the identification symbols are
the same.
When the charging connector is
inserted straight as far as possible, it
will automatically lock. Check that the
charging indicator illuminates. If the
charging indicator does not illuminate,
the charging connector is not locked.
*
: If the charging connector is not firmly
inserted, locking operation will be
performed several times.
7
If the charging indicator of the
charging port flashes after
inserting the charging connec-
tor:
The charging schedule is regis-
tered (P.136).
After temporarily removing the charging
connector, reinsert it within approxi-
mately 5 seconds. (P.131)
If the error warning indicator on the
CCID (Charging Circuit Interrupting
Device) flashes during charging, check
P.107and follow the correction proce-
dure.
The charging indicator will turn off when
charging is completed.
The charging indicator will also turn off
when charging is stopped for some rea-
son before completion. In this case,
refer to P.148.
*
Advertisement
Table of Contents
