Advertisement
Braking system
If the brake lever still feels "spongy" after completing all checks, it is necessary to bleed the
brakes using this type of procedure.
•
With the diagnostic tool properly connected, select the function "REAR BLEEDING" in the
section "SETTINGS".
•
The pump starts running.
•
While the pump is performing a rotation cycle, operate and release the rear brake pedal until
the message of diagnostic tool cycle completion is received.
•
This procedure allows the air to circulate and accumulate.
•
Once the procedure with diagnostic tool is finished, perform again the REGULAR PURGING
to remove the air from the system completely.
Front brake pump
Pos.
Description
1
Screw fastening front brake fluid res-
ervoir to bracket
2
Screw fastening brake fluid reservoir
mounting bracket to handlebar
3
Front brake pump U bolt clamp
4
Front brake lever pin fixing screw
-
Screw used to fasten the brake pipe
cable gland to the lower yoke
BRAK SYS - 450
F
RONT BRAKE MASTER CYLINDER
Type
Quantity
M6
1
M6
1
M6
2
M6
1
M5
1
RSV4 1100 Factory
Torque
7 Nm (5.16 lbf ft)
7 Nm (5.16 lbf ft)
10 Nm (7.38 lbf ft)
10 Nm (7.38 lbf ft)
8 Nm (5.90 lbf ft)
Notes
-
-
-
-
-
Advertisement
