Advertisement
RSV4 1100 Factory
CAUTION
REMOVE ANY IMPURITIES FROM THE BUSHINGS, BEING CAREFUL NOT TO SCRATCH THEIR
SURFACES.
Reassembling the fork
RSV4 1100 FACTORY (OHLINS - ASC)
NOTE
THE FOLLOWING OPERATIONS REFER TO THE OHLINS ELECTRONIC FORKS.
•
Install the following components on the
wheel holder stanchion (1) in the order
given: dust gaiter (3), retainer ring (4)
and oil seal (5).
•
Fix the sleeve in a vice, taking care not
to damage the sleeve.
•
Insert the stanchion (1) into the sleeve
(2).
•
Position the two halves of the special
tool on the shaft (1) behind shaft seal
(5), together with the respective buffer.
•
Grip the special tool and push the shaft
seal (5) into its housing on the sleeve
(2).
•
Remove the tool.
Specific tooling
AP8140189 Tool for fitting oil seal for 43 mm
(1.69 in) diameter hole
AP8140146 Weight
Suspensions
SUSP - 359
Advertisement
