APRILIA RSV4 1100 Factory 2021 Manual page 148

Electrical system
TABLE H - OBD2 CONNECTOR
•
The OBD2 wiring harness connector
must pass from the inside of the vehicle
to the outside and must be inserted in
the specific support, as indicated.
TABLE I - AMP CONNECTOR
•
After having engaged the connector in
the support, pass the wiring harness
inside, between the saddle column
frame and the under-tail fairing.
TABLE J - AMP CONTROL UNIT (IF PRESENT)
•
After having secured the control unit,
connect the connector with its counter-
part.
TABLE K - ELECTRONIC SHOCK ABSORBER
(IF PRESENT)
•
Fasten the two wiring harnesses of the
rear damper with a cable gland fixed
under the saddle.
ELE SYS - 148
RSV4 1100 Factory