Advertisement
RSV4 1100 Factory
•
Continue rotating the crankshaft (in di-
rection of rotation of engine) to bring it
back to the previous position in which
the holes in the camshaft and the bear-
ing cap were aligned; insert the refer-
ence pin while checking with the crank-
shaft reference pin, that the flywheel
side hole and the hole on the crank-
shaft are perfectly aligned.
•
If this is not the case, repeat the timing
operations.
Specific tooling
020851Y Camshaft timing pin
020852Y Crankshaft timing pin
•
Check if the clearance between the cam on the shaft and the tappet is correct.
•
If not, repeat the valve clearance adjustment procedure.
Rear head removal
In order to remove the rear head, the procedures described in the paragraph "Removing the cam-
shafts " (rear head) must be performed beforehand. Then proceed as described:
•
Unscrew and remove the chain sliders'
screws.
•
Remove the chain sliders.
•
Unscrew and remove the two head fas-
tener screws (a - b) from the clutch
side.
Engine
ENG - 279
Advertisement
