Advertisement
Braking system
Disc oscillation tolerance: 0.1 mm (0.0039 in)
Front brake disc
Removal
•
Remove the front wheel
The following operations refers to a single disc
but apply to both.
•
Unscrew and remove the six brake disc
screws (1).
•
Remove the brake disc (2).
UPON REFITTING, APPLY LOCTITE 243 ON THE THREAD
OF THE BRAKE DISC SCREWS (1).
CAUTION
UPON REFITTING, SCREW ALL THE SCREWS (1) MAN-
UALLY AND TIGHTEN THEM OPERATING DIAGONALLY
FOLLOWING THIS SEQUENCE: A-B-C-D-E-F.
See also
Removing the
front wheel
Disc Inspection
•
The following operations must be car-
ried out with the brake discs fitted on
the wheel; they refer to a single disc,
but are valid for both.
•
Check the disc for wear by measuring
the minimum thickness with a micro-
meter in different points. If the mini-
mum thickness, even in a single point
of the disc, is less than the minimum
value, replace the disc.
BRAK SYS - 442
RSV4 1100 Factory
Advertisement
