Table of Contents
Advertisement
Figure 4-4: SO-DIMM Installation
Step 1:
Open the SO-DIMM socket handles. Open the two handles outwards as far as
they can. See Figure 4-4.
Step 2:
Align the SO-DIMM with the socket. Align the SO-DIMM so the notch on the
memory lines up with the notch on the memory socket. See Figure 4-4.
Step 3:
Insert the SO-DIMM. Once aligned, press down until the SO-DIMM is properly
seated. Clip the two handles into place. See Figure 4-4.
Step 4:
Removing a SO-DIMM. To remove a SO-DIMM, push both handles outward.
The memory module is ejected by a mechanism in the
4.5 iRIS-1010 Module Installation
WARNING:
The iRIS module slot is designed to install the IEI iRIS-1010 IPMI 2.0
module only. DO NOT install other modules into the iRIS module slot.
Doing so may cause damage to the KINO-DQM871-i1.
To install the iRIS-1010 module, please follow the steps below and refer to Figure 4-6.
Page 64
KINO-DQM871-i1 Mini-ITX SBC
socket.Step 0:
Advertisement
Table of Contents
