Clear Cmos; Figure 4-8: At/Atx Mode Selection Jumper Location - IEI Technology KINO-DQM871-i1 User Manual

KINO-DQM871-i1 Mini-ITX SBC

Figure 4-8: AT/ATX Mode Selection Jumper Location

4.7.2 Clear CMOS

Jumper Label:
Jumper Type:
Jumper Location:
If the KINO-DQM871-i1 fails to boot due to improper BIOS settings, the clear CMOS
jumper clears the CMOS data and resets the system BIOS information. To do this, push
the clear CMOS button for three seconds, then restart the system.
If the "CMOS Settings Wrong" message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:

Enter the correct CMOS setting

Load Optimal Defaults

Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
J_CMOS1
Push button
See Figure 4-9
Page 69