IEI Technology KINO-DQM871-i1 User Manual page 74

WARNING:
The installation instructions described in this manual should be
carefully followed in order to prevent damage to the KINO-DQM871-i1,
KINO-DQM871-i1 components and injury to the user.
Before and during the installation please DO the following:

Read the user manual:
o
The user manual provides a complete description of the installation
instructions and configuration options.

Wear an electrostatic discharge cuff (ESD):
o
Electronic components are easily damaged by ESD. Wearing an ESD cuff
removes ESD from the body and helps prevent ESD damage.

Place on an antistatic pad:
o
When installing or configuring the motherboard, place it on an antistatic
pad. This helps to prevent potential ESD damage.

Turn all power off:
o
Make sure the product is disconnected from all power supplies and that
no electricity is being fed into the system.
Before and during the installation of the KINO-DQM871-i1 DO NOT:

DO NOT remove any of the stickers on the PCB board. These stickers are
required for warranty validation.

DO NOT use the product before verifying all the cables and power connectors
are properly connected.

DO NOT allow screws to come in contact with the PCB circuit, connector pins,
or its components.
Page 60
KINO-DQM871-i1 Mini-ITX SBC