At/Atx Mode Selection; Table 4-1: Jumpers - IEI Technology KINO-DQM871-i1 User Manual

Before the KINO-DQM871-i1 is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the KINO-DQM871-i1 are
listed in Table 4-1.
Description

AT/ATX mode selection

Clear CMOS
LVDS voltage selection
LVDS resolution selection

Table 4-1: Jumpers

4.7.1 AT/ATX Mode Selection
Jumper Label:
Jumper Type:
Jumper Settings:
Jumper Location:
Set the switch to select AT or ATX power mode for the KINO-DQM871-i1. AT power mode
limits the system to on/off. ATX allows the system to use various power saving states and
enter a standby state, so the system can be turned on remotely over a network. To
configure, see the diagram below. The default setting is ATX power mode.
Page 68
KINO-DQM871-i1 Mini-ITX SBC
J_ATXCTL1
Switch
See Figure 4-8
See Figure 4-8
Label Type
J_ATXCTL1 Switch
J_CMOS1 Push-button
JLCD_PWR1 6-pin header
SW1 DIP switch