Bay-Tek Hyper Nova Service Manual page 9

HYPERNOVA GAME SETUP
Remove the crown from the lower cabinet by removing
the 2 shipping screws using a # 2 square bit.
Since the top of the game is laying on its back, you can
now install the crown to the top of the game easily.
Attach the crown to the top of the game by installing 3 of
the 1/4" x 20 bolts, washer, & split washer with a 7/16"
socket.
Plug the CE23041 cable into the crown lighting CE23028
If game is equipped with the optional marquee sign, this
will now be removed from the lower cabinet and installed
on the upper cabinet while it is still laying on it's back.
Remove the 2 nuts holding the marquee in place using a
7/16" socket and bring marquee to the top of the upper
section. (which is still laying on its back)
Attach the optional large marquee (if purchased) to the
top of the game by installing 4 of the 1/4" x 20 bolts,
washer, & split washer with a 7/16" socket.
Plug the 4 cables into the marquee:
CE23026 to CE23063
CE23031 to CE23027
CE23032 to CE23020
AC power to AC plug
Important!
Remove the small piece of wood
and the white plastic piece from the
lower cabinet. The small piece of
wood can be discarded.
Install the white plastic piece onto
the rear of the lower cabinet to assist as a pivot point
when raising the upper cabinet up.
The top of the white plastic piece should be flush with the
top wood of the lower cabinet. Install using the 4 screws
removed earlier.
9