2N IP Force 9151101W Installation Manual page 91

added to an existing installation. Thanks to its compact dimensions, the
device can be installed into a standard mounting box.
Connection:
Connect the 2N
• To the intercom active output (OUT1 or OUT2 if a reader module or additional switch is connected)
Connect the electric lock to the 2N
• To the switched output.
• To the passive output in series with the external power supply.
The device also supports a Departure button connected between the 'PB'
and '- HeliosIP/IP intercom' terminals. Press the Departure button to activate
the output for 5 seconds.
Status signalling:
Green LED
blinking
on
blinking
on
Configuration:
®
• Connect the 2N
Manual. Make sure that one LED at least on the 2N
• Press and hold the 2N
mode (both the red and green LEDs are blinking).
• Activate the intercom switch using the keypad, telephone, etc. The first code sent from the intercom will be
stored in the memory and considered valid. After code initialisation, the 2N
the operational mode (the green LED is blinking).
®
Security Relay to the intercom as follows:
Red LED
off
off
blinking
blinking
Security Relay to the properly set intercom switch output; refer to the Configuration
®
Security Relay Reset button for 5 seconds to put the device in the programming
®
Security Relay output as follows:
Operational mode
Activated output
Programming mode – waiting for
initialisation
Error – wrong code received
®
Security Relay is on or blinking.
Installation manual 2N® IP Force
Status
®
Security Relay will pass into
91 / 118