Caution
•
The 1, 1, 1, 2, 2, 3 sequence must be entered within 30 seconds after the first sound signal for
security reasons. The inter-digit delay may be 2 s at most.
The device will have the following network parameters after restart:
•
IP address – 192.168.1.100
•
Network mask – 255.255.255.0
•
Default gateway – 192.168.1.1
Dynamic IP Address Setting for 4-button models
Follow the instructions below to enable automatic getting of network
parameters from the DHCP server:
®
•
Connect 2N
IP Force to the power supply (or, disconnect and reconnect it if already connected).
•
Wait for the first acoustic signal
•
Press buttons 2, 1, 1, 2, 2, 3 sequentially.
•
The acoustic signal
•
Wait until the device is restarted automatically.
Caution
•
The 2, 1, 1, 2, 2, 3 sequence must be entered within 30 seconds after the first sound signal for
security reasons. The inter-digit delay may be 2 s at most.
®
2N
IP Force gets the IP address upon restart only if the DHCP server is
configured properly.
indicates mode switching.
Installation manual 2N® IP Force
103 / 118