2N IP Force 9151101W Installation Manual page 44

• Stand, Part No. 9151005
• Screws suitable for the surface – are not included in the package

Caution
• Remember to fit the stand to the base thoroughly especially if there is a risk of vandalism (public
garages, etc.). Steel fitting elements are recommended.
1. Connect grounding.
2. Pull the cable
through the stand.
3. Fit the stand to the
base. Refer to the
Base drilling
template for the
dimensions of the
fitting elements. The
screws are not
included in the
package. Use screws
of your own
according to the
type of surface.
4. Use a cable bushing
®
for the 2N IP Force
cable fee-out!
Use of Cable Bushings
The cable bushings included in the 2N
following cables:
• Big bushing: for two cables of the diameter of 5–6 mm (UTP cable), or, upon insert replacement, for one
thick cable/tube of the diameter of up to 14 mm.
• Small bushing: for one cable of the diameter of 5–8 mm.
®
IP Force delivery are designed for the
Installation manual 2N® IP Force
44 / 118