directory. Call setup is signalled by a long intermittent tone or otherwise as
configured in the PBX connected.
Repeated pressing of one and the same speed dial button during call setup
may initiate call termination, or call termination plus dialling the next
telephone number of the called subscriber, or may be assigned no function.
This behaviour can be set in unit configuration.
If your model is equipped with a numerical keypad, you can also push the
button anytime to terminate a call if enabled so in the Hang up
with # parameter.
Calling to Telephone Directory Positions
®
The 2N
IP Force telephone directory can contain up to 1999 pre-
programmed positions. Speed dial can only be used for positions 1 to 4. The
remaining positions can be retrieved via the numerical keypad if the Speed
dial using digits function is enabled in configuration.
Procedure:
•
Enter the position number using your numerical keypad (05, 15, 200, 1759 e.g. – two digits at least and four
digits at most) and press
•
You can also push the
in the unit configuration.
Calling to Telephone Number
You can dial a telephone number using your numerical keypad from 2N
Force if the Enable telephone function parameter is on.
Procedure:
1.
Press the
button.
2.
You will hear the continuous tone from the loudspeaker.
3.
Enter the telephone number using the numerical keypad and repress
4.
You can also push the
with # parameter; refer to the Miscellaneous subsection.
for confirmation.
button anytime to terminate a call if enabled so in the Hang up with # parameter
button anytime to terminate a call if enabled so in the Hang up
Installation manual 2N® IP Force
for confirmation.
®
IP
105 / 118