Note
•
Be sure to press the button sequence within thirty seconds after the sound signal for security
reasons. Up to 2 s intervals are allowed between the presses.
Static IP Address Setting for 4-button models
Follow the instructions below to enable the static IP address mode:
®
•
Connect 2N
IP Force to the power supply (or, disconnect and reconnect it if already connected).
•
Wait for the first acoustic signal
•
Press buttons 1, 1, 1, 2, 2, 3 sequentially.
•
The acoustic signal
•
Wait until the device is restarted automatically.
.
indicates mode switching.
Installation manual 2N® IP Force
102 / 118