Cable Types; Cable Routing; Power Setup - Gasboy Islander Prime Instruction And Installation Manual

Preliminary Guidelines

4.5.1 Cable Types

The following are the types of cables used for the wiring of the Islander Prime system 
(see
Table 4:
No.
1
2
3
4

4.5.2 Cable Routing

Route the cables from the peripherals and the office to Islander Prime as shown below 
(see
Table 5: Islander Prime Cable Routing
No.
1
2
3
4
5
6
7
Note: The cable type number refers to the table in the above section (see

4.6 Power Setup

The power equipment must be installed in the main power cabinet. It should include the
following:
• Mains Circuit Control (MCC) Box includes dedicated circuit breaker for the pedestal
• Uninterruptible Power Supply (UPS) - Online ("True") UPS
Page 32
Table 4):
Islander Prime Cable Types
Function Type
AC Power from Power cable, 3x1.5 mm
Office standards.
Control to pumps
(valves or engine)
In-use signal
Coil (Barrier) Data communication cable, 300 V RMS, 90°C /194°F, shielded twisted pair, oil resistant, 24
AWG, low capacitance below 60 PF/meter (3.3') similar to Belden 9729 cable.
Pulser
TLG (RS-232)
LAN CAT5E, Shielded, 300 V RMS, 90°C/194°F similar to Belden 121700A.
GND Ground cable 0.4-inch (10.8-mm
Table 5):
Functional Description From
Power AC Office
GND Office
TLG Office
LAN Office
Control, Pump A Pump A
In-use, Pump A Pump A
GND Pump A
0.118 x 0.06-inch / NYY (14 AWG), in accordance with local
2 2
).
2
Through Insert Cable Type
High voltage conduit 1
High voltage conduit 4
Low voltage conduit 2
Low voltage conduit 3
High voltage conduit 1
High voltage conduit 1
Low voltage conduit 2
MDE-5411A ForeHB Islander Prime Installation Manual · October 2018
4.6 Power Setup
Table 4).