Base Plate; Figure 19 Base Plate Installation - Gasboy Islander Prime Instruction And Installation Manual

Installation

5.3.4 Base Plate

To install the base plate, proceed as follows:
Prepare the bottom plate with four ICU bolts attached to it with M10 nuts (step 1 in
1
and
Figure 19: Base Plate Installation
Insert the bottom plate in the hole.
2
Take care that all power and communication conduits pass through the central hole in the
3
bottom plate (step 2 in
Pour concrete type B200 in the hole as a support base for the pole.
4
5 Take care that as the concrete fills the hole, the bottom plate is on a same level as the ground
(asphalt, pedestal) on which it is installed. Check that the bottom plate is leveled. Otherwise
make the necessary adjustments so the plate is leveled.
6 Wait the necessary time for the concrete to harden and dry (as per local practice), and then
check again that the bottom plate is leveled.
Page 40
Figure 20). Check that the bolts protrude from the plate by 1.4-inch (35-mm).
Figure 19, 3 in Figure 20).
MDE-5411A ForeHB Islander Prime Installation Manual · October 2018
5.3 Installing the Pedestal Base
Figure 19