Pulser Connections; Figure 48 Mpi-C Fuses Diagram - Gasboy Islander Prime Instruction And Installation Manual

Installation
5.5.3.5 Fuses
Mechanical pumps are supplied with power via fuses located below the pump slots 
(see
Figure 48: MPI-C Fuses Diagram
Table 12:
In Use
INUSE1_A INUSE2_A INUSE3_A INUSE4_A LINE1
INUSE1_B INUSE2_B INUSE3_B INUSE4_B LOAD1
Table 13:
In Use
LINE1
LOAD1

5.5.4 Pulser Connections

The following describes the required wiring connections between the pulser in the mechanical
pump and Islander Prime. The system can accept many types of pulsers; contact Gasboy for
more information. There are two types of pulser:
• Electronic pulser
• Mechanical pulser
Connect Islander Prime to the pulser in accordance to its characteristics.
Note: Pulsers should be installed in accordance with the pulser manufacturer's instructions.
Page 60
Figure 48, Table 12, Table
MPI-C Fuses Slot #1- In Use/Pump
MPI-C Fuses Slot #2 - Pump/In Use
LINE2 LINE3 LINE4
LOAD2 LOAD3 LOAD4
Some pulsers do not have a barrier; in that case, you must add a pulser barrier.
Barriers are not provided with Islander Prime.
5.5 Installing Communication Interfaces
13):
Pump
LINE2
LOAD2
Pump
INUSE1_A INUSE2_A INUSE3_A
INUSE1_B INUSE2_B INUSE3_B
MDE-5411A ForeHB Islander Prime Installation Manual · October 2018
LINE3 LINE4
LOAD3 LOAD4
INUSE4_A
INUSE4_B