System Config; Protection - Eaton Cutler-Hammer FP-5000 Instructions Manual

Page 4-10
4.6.2 View Settings
Press the "View Setting" pushbutton to view the
existing settings in the FP-5000 program
settings. The red LED in the upper left-hand
portion of the pushbutton area will illuminate
while you are in the View Setting Mode. Display
4.10 shows the options provided by pressing
the "View Setting" pushbutton. Note that the
possible selections are only viewable three at
a time.
Going in to the "View Settings Mode" has no effect on the settings.
The user cannot change the settings in this mode, it's for viewing
the settings only.
Display 4.10 View Settings "Main"
Setting Main

System Config

Protection

System Alarms
Logging
Contact Input CFG
Output CFG
Programmable Logic
Communications
Select one of the Setting Main sub-menus using the Up/Down or
PgUp/PgDown pushbuttons and press the "Enter" pushbutton. This
will provide any of the monitor screens shown in the following
Display. The data in the second column is an example value, please
see Section 5 for all available settings of the FP-5000. Use the
"Previous" pushbutton to return to the "Setting Main" screen to
select another category of data screen. Note that the user can only
view the settings three lines at a time on the display. Use the Up/
Down pushbuttons to scroll through all of these settings.
Setting Main
> System Config
Protection
System Alarm
Display 4.11 View Settings
Display
Frequency: 60
Phase Seq: ABC
CT Connect: 3-wire
PH CT Ratio: 500:5
IX CT Ratio: 500:5
VT Connect: Wye
Main VTR: 100
Aux VTR: 100
Prim Units: No
I/O Config: Default
Prog Logic: Default
Remote Set: Disable
Prg w/Bkr: Either
Remote Bkr: Disable
# Set Grps: 1
Set Ctrl: Local
Disarm Trip: Disable
Energy Unit: kWh
TOC Reset: 5
Bkr Oper PB: Disable
IL17569
Display Meaning
Frequency
Phase Sequence
Ct Connection
Phase Ct ratio
Ix Ct ratio
Voltage Transformer Connection
Main Voltage Transformer Ratio
Auxiliary Voltage Transformer Ratio
Primary Units
Input/Output Configuration
Programmable Logic
Remote Set
Program With/Breaker
Remote Breaker
Number Setting Groups
Set Control
Disarm Trip
Energy Unit
Time Overcurrent Adjust Time
Breaker Operation Pushbutton
Effective June, 2001