Eaton Cutler-Hammer FP-5000 Instructions Manual page 157

Page 12-16
Open the selected file. Once this has been accomplished this
screen will automatically close and the next screen will appear
asking the user to verify the selected file. (See Figure 12-5.) If
verify is selected (highly recommended) a message will appear at
the bottom of the screen stating that "Verifying is in progress." (See
Figure 12-6.) This should take anywhere between 10 to 60 seconds
depending on the file size. Once this has been completed the
screen will automatically close and the next screen will appear. If
close is selected the screen will automatically close and the next
screen will appear.
Figure 12-5. Open S-Record File
Figure 12-6. Open S-Record File
The next screen will prompt the user to Enter-Flash-Load-Mode.
(See Figure 12-7.) Clicking on the "Enter Flash Mode" pushbutton
will prompt the user to Erase or Program the FP-5000, and will
switch the relay from normal mode to flash load mode. Note that the
Erase, Program and Exit Flash Loader pushbuttons are now
activated. (See Figure 12-8.)
Figure 12-7. Flash Programmer
Figure 12-8. Flash Programmer
Figure 12-8. Flash Programmer
IL17569
Effective June, 2001