Using The Web Interface - Keysight Technologies BT2152B Operating And Service Manual

3 Operating the Analyzer

Using the Web Interface

Your Keysight BT2152A/B has a built-in Web interface that lets you control it directly from the Web
browser on your computer. This is in addition to using the Interactive IO within the Connection Expert
to communicate with your instrument as described in
control the instrument.
With the Web interface, you can send SCPI commands directly to the instrument and also configure
the LAN settings. Multiple simultaneous LAN connections are allowed.
The built-in Web interface only operates over the LAN. A Web browser is required to
use the Web Interface.
Step 1. Open the Web browser on your computer.
Step 2. Enter the instrument's hostname or IP address into the browser's Address field. .
You can obtain the IP Address from the Connection Expert Utility in the Keysight IO Libraries. In the IO
Libraries My Instruments folder shown below, the IP address is located in the information box of the
found (checked) instrument. It is also referenced in the VISA Address and SCPI Address information
box in the Details panel.
The Web interface is enabled when shipped. After the IP address is entered into the into the browser's
Address field the following home page will appear:
42
Connect the Interfaces, or writing a program to
Keysight BT2152A/B Operating and Service Guide