Table of Contents
Advertisement
The following figure provides details about the breakout board accessory.
Review Safety Information
This instrument is a Safety Class 1 instrument, which means it has a protective earth terminal. That
terminal must be connected to earth ground through a power source equipped with an earth ground.
Refer to the
Safety Notices
the instrument and review this guide for safety warnings and instructions. Safety warnings for specific
procedures are located at appropriate places throughout this guide.
Observe Environmental Conditions
Do not operate the instrument in the presence of flammable gases or fumes.
The environmental conditions of the instrument are documented under Characteristics. Basically, the
unit should only be operated indoors in a controlled environment. Do not operate the unit in areas
where the ambient temperature is outside the 20°C to 30°C range. This applies for rack-mounting as
well as for bench use.
Provide Adequate Air Flow
Do not block the air intake at the front and side, or the exhaust at the rear of the instrument.
The dimensions of your instrument as well as an outline diagram are given under Dimensions. Fans
cool the unit by drawing air through the front and exhausting it out the side and back. The unit must be
installed in a location that allows sufficient space of at least 6 inches (15 cm) at the front and back of
the unit for adequate air circulation.
Keysight BT2152A/B Operating and Service Guide
page for general safety information. Before installation or operation, check
2 Installing the Analyzer
25
Advertisement
Table of Contents
