Rpvc Route Delete Command; Figure 283 Rpvc Route Show Command Example; Figure 284 Rpvc Route Delete Command Example - ZyXEL Communications IES-1248-71 User Manual

where
<portlist>
This command lists the domains for 2684 routed mode traffic.
The following example displays the domains for 2684 routed mode traffic for devices
connected to DSL ports 1 and 2.

Figure 283 RPVC Route Show Command Example

ras> adsl rpvc route show 1,2
port vpi vci ip/netmask
---- --- --- ------------------
1 8
2 8

56.7.10 RPVC Route Delete Command

Syntax:
ras> adsl rpvc route delete <port number> <vpi> <vci> <ip>/<netmask>
where
<port number>
<vpi>
<vci>
<ip>
/<netmask>
This command removes a domain for 2684 routed mode traffic. The domain includes the
subscriber's LAN IP addresses.
The following example removes a domain for a CPE device is connected to DSL port 1 on the
IES-1248 and the 2684 routed mode traffic is to use the PVC identified by VPI 8 and VCI 35.
The CPE device's LAN IP address is 10.10.10.10 and uses a subnet mask of 255.255.255.0.
This includes the CPE device's LAN IP addresses and the IP addresses of the LAN computers.

Figure 284 RPVC Route Delete Command Example

ras> adsl rpvc route delete 1 8 35 10.10.10.1/24
IES-1248-71/73 User's Guide
The port(s) of the RPVC.
=
You can specify a single ADSL port <1>, all ADSL ports <*> or
a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
35 10.10.10.0/24
35 10.10.11.0/24
The port of the RPVC. Specify a single ADSL port <1>.
=
The VPI of the RPVC.
=
The VCI of the RPVC.
=
The subscriber's CPE LAN IP address in dotted decimal
=
notation.
The bit number of the subnet mask of the subscriber's IP
=
address. To find the bit number, convert the subnet mask to
binary and add all of the 1's together. Take "255.255.255.0" for
example. 255 converts to eight 1's in binary. There are three
255's, so add three eights together and you get the bit number
(24).
Chapter 56 Virtual Channel Management
409