Tls Pvc Delete Command; Tls Pvc Set Command - ZyXEL Communications IES-1248-71 User Manual

Chapter 56 Virtual Channel Management
You can NOT configure PPPoA-to-PPPoE and TLS settings on the same PVC.

56.9.1 TLS PVC Delete Command

Syntax:
ras> adsl tlspvc delete <portlist> <vpi> <vci>
where
<portlist>
<vpi>
<vci>
This command clears TLS settings for the PVC.

56.9.2 TLS PVC Set Command

Syntax:
ras> adsl tlspvc set <portlist> <vpi> <vci> <DS vcprofile[,US vcprofile]>
<pvid> <priority>
where
<portlist>
<vpi>
<vci>
<DS vcprofile
[,US
vcprofile]>
<pvid>
<priority>
This command sets the second VLAN tag to add to the packets from the PVC.
The following example adds VLAN tag 100 to traffic using the DEFVAL ATM profile on
PVC (1/33) on port 2.
416
The port number of the TLS PVC. You can specify a single
=
ADSL port <1>, all ADSL ports <*> or a list of ADSL ports
<1,3,5>. You can also include a range of ports <1,5,6~10>.
The VPI of the TLS PVC.
=
The VCI of the TLS PVC.
=
The port number of the TLS PVC. You can specify a single
=
ADSL port <1>, all ADSL ports <*> or a list of ADSL ports
<1,3,5>. You can also include a range of ports <1,5,6~10>.
The VPI of the TLS PVC.
=
The VCI of the TLS PVC.
=
Assign a VC profile to use for this channel's downstream traffic
=
shaping.
Assign a VC profile to use for policing this channel's upstream
=
traffic. The IES-1248 does not perform upstream traffic policing
if you do not specify an upstream VC profile.
1 – 4094; the (second) VLAN Identifier to add to Ethernet
=
frames that the system routes using this PVC.
Set the IEEE 802.1p priority (0~7) to add to the traffic that uses
=
this PVC.
IES-1248-71/73 User's Guide