Route Delete Command; Subnet Flush Command; Route Add Command; Route Flush Command - ZyXEL Communications ZyXEL DMA 1000 User Manual

IES-1000 User's Guide
12.2.7

Subnet Flush Command

Syntax:
192.168.1.1 ip> subnet flush
This command removes all of the subnets.
12.2.8

Route Add Command

Syntax:
192.168.1.1 ip> route add <dom name> a.b.c.d <relay> [am:bm:cm:dm [<cost>
]]
where
<dom name>
a.b.c.d
<relay>
am:bm:cm:dm
<cost>
This command defines a new, static IP forwarding route or edits an existing one. Type "route" without any
parameters to view a list of the configured static routes.
Use 0's for the destination IP address and subnet mask to configure a default static route for the device. The
device uses the default static route to forward packets for which it cannot find another route. The following is
the syntax for configuring a static route.
192.168.1.1 ip> route add <dom name> 0.0.0.0 <relay> 0:0:0:0
12.2.9

Route Delete Command

Syntax:
192.168.1.1 ip> route delete <dom name>
where
<dom name>
This command removes a static, IP forwarding route.
12.2.10

Route Flush Command

Syntax:
192.168.1.1 ip> route flush
This command removes all of the static IP forwarding routes.
12-4
= The name of the static route.
= The destination IP address of packets that this static route is to route.
= The IP address of the gateway that you want to send the packets through.
= The destination subnet mask of packets that this static route is to route.
= The metric (hop count) of this static route.
= The name of the static route.
IP Commands