ZyXEL Communications IES-1248-71 User Manual page 280

Chapter 44 Commands
Table 92 Commands (continued)
CLASS COMMAND
timeserver set
timeserver sync
log show
log clear
wdog show
wdog set
monitor show
monitor enable
monitor disable
monitor vlimit
monitor tlimit
monitor flimit
monitor extalm
user online
user enable
user disable
user set
280
PARAMETERS DESCRIPTION
Sets the time service protocol,
<time|ntp> <ip>
time server's IP address and the
<utc[<+|-
device's time zone.
>0100~1200]>
[nosync]
Retrieves the date and time from
the time server.
Displays the device's logs.
Clears the device's logs.
Displays the current watchdog
firmware protection feature status
and timer.
Sets the watchdog count. 0 turns
<msec|0:disable>
the watchdog off.
Displays the hardware monitor's
statistics.
Turns the hardware monitor on.
Turns the hardware monitor off.
Sets the maximum (<high>) or
<idx> <high> <low>
minimum (<low>) voltage at the
specified voltage sensor. You can
specify a voltage with up to three
digits after a decimal point (0.941
for example).
Normal voltage at each sensor:
Idx: 1=1.0v, 2=1.8v, 3=3.3v, 4=24v
Sets the maximum (<high>) or
<idx> <high> <low>
minimum (<low>) temperature at
the specified temperature sensor.
You can specify a temperature
with up to three digits after a
decimal point (-50.025 for
example).
Temperature sensor locations:
Idx: 1=DSL, 2=CPU, 3=HW
monitor
Sets the maximum (<high>) or
<idx> <high> <low>
minimum (<low>) fan revs per
minute (RPM) at the specified fan
(<idx>).
Idx: 1=Fan 1, 2=Fan 2, 3=Fan 3.
Set external alarm name.
<idx> <name>
Displays online user info.
Turns on the specified user name
<name>
of multi-login.
Turns off the specified user name
<name>
of multi-login.
Creates or edits the password and
<username>
privilege level of the specified
<password>
user name.
<high|middle|low>
P
H/H
H/H
M/L
H/H
H/~
H/~
L/L
H/H
H/H
H/H
H/H
H/H
H/H
M/~
H/H
H/H
H/H
IES-1248-71/73 User's Guide