Log Clear Command; Info Show Command - ZyXEL Communications IES-1248-71 User Manual

Chapter 45 Command Examples
Table 94 Log Messages (continued)
LOG MESSAGE
THERMO OVER
TEMPERATURE: dev:<id>
threshold:<threshold>
(degree C)
value:<temp>(degree
C)!
THERMO OVER
TEMPERATURE released:
dev:<id>
threshold:<threshold>
(degree C)
value:<temp>(degree
C)!
THERMO OVER VOLTAGE:
dev: <id> limit:
<threshold> value:
<voltage>!
THERMO OVER VOLTAGE
released:
nominal:<nominal>(mV)
value:<voltage> (mV)!

45.3.2 Log Clear Command

Syntax:
ras> sys log clear
This command clears the system error log.
If you clear a log (using the log clear command), you cannot view it again.

45.3.3 Info Show Command

Syntax:
ras> sys info show
This command shows general system settings, the BIN (firmware) version, system uptime and
bootbase version.
300
TYPE DESCRIPTION
The temperature was too high at one of the temperature sensors.
WARN
<id> -
0: sensor near the ADSL chipset
1: sensor near the CPU
2: thermal sensor chip
<threshold> - temperature limit
<temp> - temperature when the entry was logged
The temperature at one of the temperature sensors has come back to
INFO
normal.
<id> -
0: sensor near the ADSL chipset
1: sensor near the CPU
2: thermal sensor chip
<threshold> - temperature limit
<temp> - temperature when the entry was logged
The voltage at one of the voltage sensors went above the accepted
WARN
operating range.
<id> 1=1.0v, 2=1.8v, 3=3.3v, 4=24v
<threshold> - voltage limit
<voltage> - voltage of the DC power when logged
The device's voltage is back inside the accepted operating range.
INFO
<nominal> - nominal voltage of the DC power
<voltage> - voltage of the DC power when logged
IES-1248-71/73 User's Guide