Table of Contents
Advertisement
where
<profile>
This command allows you to delete an individual ADSL profile by its name. You cannot
delete a profile that is assigned to any of the DSL ports in the IES-1248. Assign a different
profile to any DSL ports that are using the profile that you want to delete, and then you can
delete the profile.
The following example deletes the gold ADSL profile.
Figure 229 ADSL Profile Delete Command Example
ras> adsl profile delete gold
55.1.7 ADSL Profile Map Command
Syntax: (IES-1248-71/71A)
ras> adsl profile map <portlist> <profile>
-> <glite|gdmt|t1413|auto|adsl2|adsl2+>
Syntax: (IES-1248-73)
ras> adsl profile map <portlist> <profile>
-> <anxb|etsi|auto|adsl2|adsl2+>
where
<portlist>
<profile>
<glite|gdmt|ets
i|t1413|auto|ad
sl2|adsl2+>
This command assigns a specific profile to an individual port and sets the port's ADSL mode
(or standard). The profile defines the maximum and minimum upstream/downstream rates, the
target upstream/downstream signal noise margins, and the maximum and minimum upstream/
downstream acceptable noise margins of all the ADSL ports to which you assign the profile.
When set to auto, the port follows whatever mode is set on the other end of the line.
When the mode is set to
negotiated ADSL mode regardless of the rates configured in the profile. For
example, if the profile is set to use a rate of 18000 Kbps, that speed is only
supported if the negotiated ADSL mode is ADSL 2+. Any other ADSL mode
will limit the rate to what is supported by the specific ADSL standard.
IES-1248-71/73 User's Guide
A profile name.
=
You can specify a single ADSL port <1>, all ADSL ports <*> or
=
a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
The profile that will define the settings of this port.
=
The ADSL operational mode. The IES-1248-71/71A and the
=
IES-1248-73 have different choices.
, the connection rates are governed by the
auto
Chapter 55 ADSL Commands
369
Advertisement
Table of Contents
Troubleshooting
