Figure 59 Xdsl Port Setting; Table 20 Xdsl Port Setting - ZyXEL Communications IES-1248-71 User Manual

Chapter 16 xDSL Port Setup

Figure 59 xDSL Port Setting

The following table describes the labels in this screen.

Table 20 xDSL Port Setting

LABEL
Last Page
Active
Customer Info
Customer Tel
Profile
Mode
Alarm Profile
126
DESCRIPTION
Click this to return to the previous screen.
Select this check box to turn on this ADSL port.
Enter information to identify the subscriber connected to this ADSL port. You
can use up to 31 printable ASCII characters (including spaces and hyphens).
Enter information to identify the telephone number of the subscriber connected
to this ADSL port. You can use up to 15 ASCII characters (including spaces and
hyphens).
Select a profile of ADSL settings (such as the transfer rate, interleave delay and
signal to noise ratio settings) to assign to this port. Use the Port Profile screen
to configure port profiles (see
Select the port's ADSL operational mode. Select the mode that the subscriber's
device uses or auto to have the IES-1248 automatically determine the mode to
use. See Table 18 on page 121
Select the port's alarm profile. The alarm profile defines alarm thresholds for the
ADSL port. The IES-1248 sends an alarm trap and generates a syslog entry
when the thresholds of the alarm profile are exceeded (see
page 145).
Chapter 17 on page 137).
for information on the individual ADSL modes.
IES-1248-71/73 User's Guide
Section 17.6 on