Signal Routing; Waveform Control - Pacific UPC-32 Operation Manual

SECTION 5 REMOTE OPERATION

5.4.2 SIGNAL ROUTING

:[SOURce:]FORM <n> Sets Output power form.
:[SOURce:]COUPLing <s>
:[SOURce:]VOLTage:ALC[:STATE] <b> The ALC keyword controls CSC enable/disable.
:SENSe:PATH <s>
:SENSe:SPECTrum:RANGe <n> (option: Harmonic Analysis and Synthesis)
:OUTPut[:STATE] <b> Command: OUTPUT ENABLE, opens or closes the power source output relay.

5.4.3 WAVEFORM CONTROL

:PROGRAM:NAME <WFnn>
:PROGram:[SELected:]DEFine <data>
n = <1>Single Φ, <2>Split Φ, or <3>Three Φ
Sets Output coupling.
s = <DIRECT> or <XFMR>
b = <OFF> or <ON> or <0>OFF or<1>ON
Selects source location for metering and CSC.
s = <0>Internal or <1>External
Sets the number of data samples per cycle used for harmonic analysis.
The number of harmonics calculated is n/2, e.g. if n=64 then the
highest harmonic calculated is the 32
are valid values for n. If any other value is sent, the default value of
128 will be used. See para. 4.3.1.1.
n = 512, 256, 128, 64, 32, 16 (default is 128)
b = <OFF> or <0>, <ON> or <1>
Query: returns actual state of output relays, <0>OFF or <1>ON, not
the OUTPUT ENABLE value
NOTE: Setting the OUTPUT POWER ON-AUTO/OFF switch (front
panel of the power source) to OFF, overrides the OUTPUT ENABLE
command.
selects waveform "nn" for loading or data query.
nn = 2 to 16 for data defining (loading) or 1 to 32 for data query.
loads selected waveform (2-16) with data from the IEEE-488 Bus. The
number of data elements must be 1024, representing 0-359.7 degrees
in 0.3512º steps. Each element is a signed percentage of peak full
scale voltage and may have a maximum of 2 decimal digits. Each
element must be separated by a comma.
NOTE: Only commas may separate the values, NO Carriage Returns
or Line Feeds may separate the values.
e.g., <0,+5.23,+10,-50,+20,+25.7,+30,-43.91,+100> %.
86
nd
. Only the numbers listed below