Pacific UPC-32 Operation Manual page 105

5.5.3.1 IEEE-488.2 STATUS REPORTING (cont)
IEEE-488.2 STATUS REPORTING COMMANDS
NAME
*IDN?
*CLS
*STB?
*SRE <n>
*SRE?
*ESE <n>
*ESE?
*ESR?
*OPC
*OPC?
5.5.3.2 SCPI STATUS REPORTING
The following lists the SCPI Commands for Status Reporting from the UPC. Refer to the SCPI 1992
standard for more information. Query commands are explicitly shown in this section for clarity. Refer to
figure 5.3. See section 5.2 Conventions regarding SCPI.
:SYSTem:ERRor?
:SYSTem:VERSion?
DEFINITION
Device Identification query. Returns <PPSC,UPC-MM,vN.NN,1338XX> where
MM is the model number (12 or 32),
N.NN is the firmware version number
XX is the firmware assembly indicating installed options
Clears the ESR and the STB registers as well as the SCPI :EVENt registers and
ERROR/EVENT queue
Read status byte query. Bit 0 is Power Source SHUTDOWN
Service request enable command
Service request enable query
Standard event status enable
Standard event status enable query
Standard event status register query
Operation complete command
Operation complete query
Query: system error
Returns one of the following types of messages, with details appended to it if possible.
A maximum of 256 characters may be sent as a response to this query.
-0, "No error"
-100, "Command error"
-200, "Execution error"
-300, "Device-specific error"
-400, "Query error"
NOTE: The SYSTem:ERRor query clears the corresponding error bit in the ESR.
Query: SCPI version.
SECTION 5
No error detected
indicates invalid command or query received
indicates can't execute command with
parameters received
indicates UPC not properly configured
indicates query aborted
Returns <1992.0>.
93
REMOTE OPERATION