Ieee-488.2 Device Control Commands - Pacific UPC-32 Operation Manual

SECTION 5 REMOTE OPERATION

5.6.2 IEEE-488.2 DEVICE CONTROL COMMANDS

The following lists the IEEE-488.2 Common Commands for Device Control of the UPC. Refer to the
ANSI/IEEE-488.2 1987 standard for more information.
*RST
*TST?
*WAI
*TRG
*LLO
*GTL
*DCL
Command: RESET. Initialize the UPC with the following parameters:
CSC
CURRENT LIMIT
INITIAL VOLTAGE
KEYBOARD LOCK
MAX FREQUENCY
MAX VOLTS
MIN FREQUENCY
MIN VOLTS
MODE
OUTPUT
OUTPUT COUPLING
OUTPUT FORM
OUTPUT FREQUENCY
OUTPUT VOLTAGE(S)
PHASE ANGLE B
PHASE ANGLE C
PROG. Zo
RANGE CONTROL
SENSE
TRANSITION TIME
WAVEFORM ΦA
WAVEFORM ΦB
WAVEFORM ΦC
NOTE: Stored programs are not erased.
Query: Self test. Test validity of non-volatile RAM.
Returns 0 if no error.
Command: Wait-to-continue. Only useful following the :PROG:EXEC:TRANS or
*TRG commands. All other commands are executed sequentially as the
Program Message is parsed.
Command: IEEE-488.2 Device trigger function. Executes Transient Events (if
any), of currently executed program.
Command: LOCAL LOCKOUT. Puts the UPC into REMOTE mode and
disables local operation of the UPC keyboard.
Command: GOTO LOCAL. Enables local operation of the UPC keyboard.
Command: DEVICE CLEAR. Performs a hardware RESET of the UPC.
98
OFF
CURRENT METERING RANGE
0
OFF
5000 Hz
600 V
45 Hz
0 V
MANUAL
DISABLED
DIRECT
1 or 3 (depending on model)
60 Hz
0
120º
240º
OFF
AUTO
INTERNAL
0
1
1
1