Pacific UPC-32 Operation Manual page 87

4.6.3.7 INITIAL VOLTAGE
Selecting INITIAL VOLTAGE from the General Setup 2 menu (fn,3,7,1) allows you to specify the initial
power up output voltage amplitude.
INITIAL VOLTAGE SETUP:
VOLTAGE=0
(Press +/- Key to Toggle Selection
(Press ENTER or EXECUTE to Exit
VOLTAGE=:
NOTE: The default factory setting for INITIAL VOLTAGE is 0.
4.6.3.8 KEYBOARD LOCK
Selecting KEYBOARD LOCK from the General Setup 2 menu (fn,3,7,2) allows you to control the
keyboard lock feature.
KEYBOARD LOCK SETUP: LOCK=OFF
(Press +/- Key to Toggle Selection
(Press ENTER or EXECUTE to Exit
LOCK=:
NOTE: The default factory setting for KEYBOARD LOCK is off.
0 or LAST EXECUTED. If 0 is chosen, the unit will set the output voltage to 0
regardless of output voltage prior to turning the unit off. Choosing LAST EXECUTED
means the power source will automatically power on with the output voltage setting that
existed prior to turning the unit off. The output relay will always be open at power-up
unless an "Auto-Start" option has been installed.
OFF or ON. If OFF is chosen, the keyboard is always enabled. If ON is chosen, the
keyboard is locked and disabled after pressing the DISPLAY key. Key presses are
ignored when the keyboard is locked. The only exceptions are the CLEAR key and
OUTPUT ENABLE key. To enable the keyboard, press the fn and EDIT keys at the
same time. The keyboard remains enabled until you press the DISPLAY key.
75
SECTION 4 OPERATION