Pacific UPC-32 Operation Manual page 65

4.5.2.1 TIME BASED TRANSIENT EXAMPLE
The following is an example of how to create a MIL-STD-704D time-based transient. (See section 4.4.2
regarding pre-stored transients)
Start with the previous program #4 example as shown in section 4.5.1. From any metering display press
PROGRAM, 4, ENTER, EDIT, EDIT, and you should see the following display:
TRANSIENT: PRGM #4
T=0.0002
F=400
Press 1, ENTER, ENTER, to select segment 1 of 1.
TRANSIENT: PRGM #4
T=.0002
F=400
Press .OOO2, ENTER, to select a time of .0002 seconds. This is the smallest time allowed for a time
based transient segment.
TRANSIENT: PRGM #4
T=0.0002
F=400
Press 80, ENTER, 80, ENTER, 80, ENTER, to select 80 volts on all three phases.
TRANSIENT: PRGM #4
T=0.0002
F=400
Press 400, ENTER, to select 400 Hz. output frequency.
TRANSIENT: PRGM #4
T=0.0002
F=400
SEGMENT #1
Va=108 Vb=108
WFa=1 WFb=1
SEGMENT #1
Va=108 Vb=108
WFa=1 WFb=1
SEGMENT #1
Va=108 Vb=108
WFa=1 WFb=1
SEGMENT #1
Va=80 Vb=80
WFa=1 WFb=1
SEGMENT #1
Va=80 Vb=80
WFa=1 WFb=1
53
SECTION 4
OF 1
Vc=108
WFc=1
OF 1
Vc=108
WFc=1
OF 1
Vc=108
WFc=1
OF 1
Vc=80
WFc=1
OF 1
Vc=80
WFc=1
OPERATION