Setup Mode; Program Setup; Figure 4.5.2.2 Spike Transient - Pacific UPC-32 Operation Manual

SECTION 4 OPERATION
4.6

SETUP MODE

SETUP MODE is used to:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
From any meter display, press the fn key to enter SETUP MODE.
SETUP: PRESS 1 FOR PROGRAM SETUP

4.6.1 PROGRAM SETUP

PROGRAM SETUP is used to copy and delete programs and erase memory.
From any METER display (V/I, AMPS or POWER), press the fn key to enter SETUP MODE.
From the SETUP display, press 1 to enter PROGRAM SETUP.
PROGRAM SETUP: PRESS
1 TO COPY A PROGRAM,
2 TO DELETE A PROGRAM,
3 TO ERASE ALL MEMORY AND RESET CPU.
Copy and Delete Programs
Copy, Edit, and Create Waveforms
Set Min. and Max. Voltage Limits
Set Min. and Max. Frequency Limits
Engage and Disengage CSC (Continuous Self Calibration)
Set the Metering Sense Point – Internal or External
Set Slew rates
Set Transition Time
Set Transformer Ratio
Enable keyboard lockout
Set initial power on output voltage
Monitor UPC and Power Source status
View Firmware Version
Enable Calibration Mode for Metering
Adjust LCD View Angle and Backlight Intensity
Set GPIB Device Address or Serial Interface Parameters
Erase Memory
Set Amps-to-Volts Current Metering Ratio
Define Current Transformer Location
Set Output Range - for power sources that support it
Display the Number of Power Source Amplifiers
Synthesize Waveforms from Harmonic values (Option)
Calibrate Programmable output impedance (Option)
Enable and Set Programmable Output Impedance (Option)
2 FOR WAVEFORM SETUP
3 FOR GENERAL SETUP
4 FOR CALIBRATION MENU.
60