Configure Gpib Device Address; Configure Miscellaneous Settings - Pacific UPC-32 Operation Manual

SECTION 3 INSTALLATION

3.4.3 CONFIGURE GPIB DEVICE ADDRESS

Set the GPIB DEVICE ADDRESS as desired. The GPIB device address is set via the UPC STATUS
display screen. Default address is 1. See paragraph 4.6.3.3 for configuration.
NOTE: IEEE-488 type cables with 90º "cable to connector" bends may interfere with other interface
connectors on the SCU and some power source model's rear panels. It is recommended that a straight
"cable to connector" IEEE-488 cable be used (e.g. NATIONAL INSTRUMENTS type X5) or a 90º
adapter may be used to provide needed clearance.

3.4.4 CONFIGURE MISCELLANEOUS SETTINGS

NOTE: Most users will not need to concern themselves with the unit's configuration settings as it is set
at the factory if the UPC is packaged with a power source.
These settings are set by SWITCH S1 on the UPC INTERFACE PCB (figure 3.4.4) and SWITCH S2 on
the UPC METERING PCB (figure 3.4.1).
PCB
INTERFACE
INTERFACE
INTERFACE
INTERFACE
INTERFACE
INTERFACE
METERING
DIP-SWITCH CONFIGURATION SETTINGS
FIGURE Switch Position
3.4.4 S1-1 ON
S1-1 OFF
3.4.4 S1-2 ON
S1-2 OFF
3.4.4 S1-5 ON
S1-5 OFF
3.4.4 S1-6 ON
S1-6 OFF
3.4.4 S1-7 ON
S1-7 OFF
3.4.4 S1-8 ON
S1-8 OFF
3.4.1 S2-7 ON
S2-7 OFF
Description
Current transformer on primary side of XFMR
Current transformer on secondary side of XFMR
1 PA installed
See METERING PCB SW2-7 below
RS-232 INTERFACE INSTALLED
IEEE-488 INTERFACE INSTALLED
FRONT PANEL INSTALLED
FRONT PANEL NOT INSTALLED.
maximum REMOTE INTERFACE performance.
METERING PCB INSTALLED
METERING PCB NOT INSTALLED.
enhanced Transient and REMOTE INTERFACE
performance. OFF position ignored if CSC is
enabled.
ΦB AND ΦC OSCILLATOR PCBS INSTALLED;
Allows for 3Φ operation.
ΦB AND ΦC OSCILLATOR PCBS NOT INSTALLED
2 power amplifiers installed
3 power amplifiers installed
26
Allows for
Allows for