Pacific UPC-32 Operation Manual page 84

SECTION 4 OPERATION
4.6.3.3 UPC STATUS
UPC STATUS indicates firmware version, GPIB or RS-232 SERIAL interface status, and DIP switch
settings. It also allows the user to set the GPIB device address. See section 10 if the RS-232 SERIAL
REMOTE INTERFACE is installed. The UPC SETUP menu is accessed from the General Setup menu
(fn,3,1).
From any METER display (V/I, AMPS or POWER), press the fn key to enter SETUP MODE.
From the SETUP display, press 3 to enter GENERAL SETUP.
From the GENERAL SETUP display, press 3 to enter UPC STATUS.
For systems equipped with a GPIB (IEEE-488) communication port, the display will be:
UPC STATUS: FIRMWARE 133863 v2.51
GPIB ADDRESS 1
TRANSFORMER RATIO 2.00 PAs=3
AMPS:VOLTS RATIO 4.00A=1 V PRI
If your UPC is configured with a serial port interface the UPC STATUS screen is:
UPC STATUS: FIRMWARE 133863 v2.51
BAUD 19200. PARITY:NONE
TRANSFORMER RATIO 2.00 PAs=3
AMPS:VOLTS RATIO 4.00A=1 V PRI
To change any of these settings, press ENTER to move the cursor to each data field. Press EDIT when
the cursor is positioned on the value to be changed. Type the new value, then press ENTER to continue
editing or STORE to save and exit.
GPIB ADDRESS:
IFC:
LAST DATA BYTE=
BAUD:
PARITY:
LAST BYTE=
IFC LAST DATA BYTE=00h
LAST BYTE=00h
0 to 30. This is the IEEE-488 device address for the UPC. To change
the address, press EDIT, enter a valid number then press ENTER or
STORE. The factory default address is 1.
"Interface Clear". This is displayed only if an IEEE-488 Interface
Clear message is received while this status display is shown. This
display latches the IFC message. Press CLEAR to clear this display
and the IFC field. It is used for troubleshooting the GPIB interface.
This field indicates the last data byte (DAB) received by the GPIB
interface. The byte is shown in hexadecimal format. Hex 0D (Carriage
Return) is displayed as Hex 0A (New Line).
troubleshooting the GPIB interface.
300, 1200, 2400, 4800, 9600, 19200, 38400. This is the serial port
baud rate. The factory default value is 19200.
NONE, ODD or EVEN. The default serial port parity value is NONE.
Same as LAST DATA BYTE, above.
72
EOS=CR/LF
This is used for