Check Point QUANTUM MAESTRO Manual page 41

To see the state of split ports, it is necessary to use the control button to select the LED indication mode.
The control button (item 1) selects one of the five available LED indication modes in a cycle.
The four LEDs in the section
The port LEDs (item 3) show the port state - link (up or down) and traffic (flowing or not).
Indication LEDs in the section
Mode "SPLIT"
0 All LEDs are off
/1 Only the first LED from
the left is lit (/1)
/2 Only the second LED
from the left is lit (/2)
/3 Only the third LED from
the left is lit (/3)
/4 Only the fourth LED
from the left is lit (/4)
SPLIT /1 /2 /3 /4 (item 2) show the current LED indication mode.
Description
Port LEDs show the state of physical ports.
Use this indication mode when no breakout cables are
connected.
Port LEDs show the state of the first split port of the
physical port.
Example:
If you connect a breakout cable to port 8 (interface eth1-
29), then in this LED indication mode /1,
the port LED 8 shows the state of the interface eth1-29
(Port 1/8/1).
Port LEDs show the state of the second split port of the
physical port.
Example:
If you connect a breakout cable to port 8 (interface eth1-
29), then in this LED indication mode /2,
the port LED 8 shows the state of the interface eth1-30
(Port 1/8/2).
Port LEDs show the state of the third split port of the
physical port.
Example:
If you connect a breakout cable to port 8 (interface eth1-
29), then in this LED indication mode /3,
the port LED 8 shows the state of the interface eth1-31
(Port 1/8/3).
Port LEDs show the state of the fourth split port of the
physical port.
Example:
If you connect a breakout cable to port 8 (interface eth1-
29), then in this LED indication mode /4,
the port LED 8 shows the state of the interface eth1-32
(Port 1/8/4).
Quantum Maestro Getting Started Guide | 41
LEDs