Check Point QUANTUM MAESTRO Manual page 168

Step Instructions
8 Follow these configuration steps:
a. Configure the applicable Security Groups on the Quantum Maestro Orchestrators.
b. Configure the Gaia Operating System settings in the new Security Group.
c. Configure the settings in SmartConsole.
See the Maestro Administration Guide for your version > Chapter Configuring Security
Groups .
Important Notes for configuring the applicable Security Groups:
Perform the configuration of Security Groups only on one Quantum Maestro
n
Orchestrator.
The Quantum Maestro Orchestrators synchronize the configuration automatically on
each site and between the sites.
To create a new Security Group when the SMO Image Cloning is enabled , follow the
n
procedure below.
Procedure
a. Create a new Security Group that contains interfaces and Security
b. Connect to the command line of the Security Group over SSH at <IP
d. Add to this Security Group the Security Appliances from Site 2.
Appliances only from Site 1.
Address of Security Group>.
When you log in, the Gaia gClish opens by default.
Important - This connection goes through the Quantum Maestro
Orchestrator's management interface you assigned to this
Security Group.
c. Configure the total number of Sites:
set smo security-group site-amount 2
The Security Appliances on Site 2 automatically clone the software and the
configuration from the SMO Security Appliance on Site 1.
Dual Site with four Switches
Quantum Maestro Getting Started Guide | 168