Check Point QUANTUM MAESTRO Manual page 154

Step Instructions
6 Configure the Site ID on each Quantum Maestro Orchestrator.
Configuring the Site ID on the first site
a. Connect to the command line on each Orchestrator.
b. Log in to Gaia Clish.
c. Configure the same Site ID 1 on each Orchestrator:
set maestro configuration orchestrator-site-id 1
For information about this Gaia Clish command, see the Maestro Administration
Guide for your version > Chapter Configuring Security Groups > Section
Configuration Procedure > Section Configuring Security Groups in Gaia Clish >
Section Configuring the Site ID in Dual Site Deployment .
d. Restart the orchd daemon on each Orchestrator.
Log in to the Expert mode and run this command:
orchd restart
Configuring the Site ID on the second site
a. Connect to the command line on each Orchestrator.
b. Log in to Gaia Clish.
c. Configure the same Site ID 2 on each Orchestrator:
set maestro configuration orchestrator-site-id 2
d. Restart the orchd daemon on each Orchestrator.
Log in to the Expert mode and run this command:
orchd restart
Warning - No traffic flows through the Quantum Maestro Orchestrator
until this daemon restarts.
Warning - No traffic flows through the Quantum Maestro Orchestrator
until this daemon restarts.
Dual Site with two Switches
Quantum Maestro Getting Started Guide | 154