Check Point QUANTUM MAESTRO Manual page 145

Step Instructions
11 On the existing site (Site ID 1), apply the current configuration on the first Orchestrator
(Orchestrator ID 1_1).
It is possible to apply the current configuration in one of these ways:
In Gaia Portal
For information, see the Maestro Administration Guide for your version > Chapter
Configuring Security Groups > Section Configuration Procedure > Section Configuring
Security Groups in Gaia Portal .
a. With a web browser, connect to the Gaia Portal on the Quantum Maestro
Orchestrator:
https://<IP Address of Orchestrator's MGMT Port>
b. Log in to the Gaia Portal.
c. From the left navigation tree, click
d. In the bottom left corner, click Apply.
In Gaia Clish
For information, see the Maestro Administration Guide for your version > Chapter
Configuring Security Groups > Section Configuration Procedure > Section Configuring
Security Groups in Gaia Clish .
a. Connect to the command line on the Quantum Maestro Orchestrator.
b. Log in to Gaia Clish.
c. Apply the configuration:
set maestro security-group apply-new-config
12 Optional: Enable the SMO Image Cloning.
See the Gaia Administration Guide for your version > Chapter Maintenance > Section
Snapshot Management > Section SMO Image Cloning .
13 On the existing site (Site ID 1), add Security Appliances from the new site (Site ID 2) to this
Security Group.
It is possible to change the configuration in one of these ways:
In Gaia Portal
n
In Gaia Clish
n
See the Maestro Administration Guide for your version > Chapter Configuring Security
Groups > Section Configuration Procedure .
Dual Site with Direct Connection
Orchestrator page.
Quantum Maestro Getting Started Guide | 145